Page 2 of 2 <12
Topic Options
Rate This Topic
#180358 - 04/20/17 02:33 PM Re: First attempt at camo swirl paint [Re: PsTaN]
TXBRASS
member


Registered: 09/05/15
Posts: 109
Loc: TX

Offline
I prepped and sanded the stock as usual. I then cleaned it well with clean rag with acetone. I then used an adhesion promoter, waited the 3 minutes and then topcoated with Krylon supermax and fusion camo. I sprayed it all tan and then put a top edge of OD green. This was all done (at Krylon's recommendation) within a few minutes of each step so the paint could bond together. I then let the stock flash cure for about 30 minutes while I prepped the water. I have a large trash can that I put a liner in and and filled with water. I used Embrol tester paints which I got on **** shipped for like $2.50 each from ****. I dropped the colors on top, swirled, and then dipped the stock. Once I took it out, I dabbed the paint with a clean rag and then dried it off with a hair dryer as it hung. I then hung it in front of a fan for 12 hours and then 7 hours in the kitchen oven at low temp. I will now clear with Spraymax 2K which is a 2-part matte clear that is auto quality.
_________________________
Get your W-GEAR Guardian Scabbard. The only carry option built solely for use with specialty pistols!
100% MADE IN THE USA.
LIFETIME WARRANTY

http://www.codyweiser.com

- SHORT STICK BANG GANG -

Top
#180363 - 04/20/17 05:07 PM Re: First attempt at camo swirl paint [Re: TXBRASS]
thadf
member


Registered: 09/06/12
Posts: 169
Loc: Missouri

Offline
Holy cow!!! That's cool.

Yours looks really good.

Top
Page 2 of 2 <12


Moderator:  jamesfromjersey, Gregg Richter, Dan B., ClayFHT, Gary 
Hop to:
 Portal Sidebar
Who's Online
8 registered (bullsi1911, tradmark, bowmag, Whitworth, kalhoon, PythonHunter) and 119 anonymous users online.
Top Posters
9126
s4s4u
8950
Whitworth
7641
wapitirod
7525
jamesfromjersey
7327
TCTex.
5824
KRal
4992
Gary
4704
Tigger
4662
Ernie
4370
Dan B.
3885
pab1
3755
johnwilliams
3720
TN Lone Wolf
3695
Gregg Richter
3342
Raptortrapper
  Member Hunts
Best Contender Bar
Best Contender Barrels - Custom or Factory?

Handgun Challenge
Handgun Challenge

   Access Requires Login

Generated in 0.031 seconds in which 0.008 seconds were spent on a total of 14 queries. Zlib compression enabled.




Copyright © 2000-2008
HandgunHunt.com, Inc.